Ren-iz Shrine
Jump to navigation
Jump to search
Want an adless experience? Log in or Create an account.
Ren-iz Shrine
Games | ||
Location | ||
Depths Counterpart | ||
Items | ||
Rewards | ||
| Attributes | ||
|---|---|---|
Type | ||
Ren-iz Shrine, titled Jump the Gaps, is a Shrine of Light from Tears of the Kingdom.
This shrine is found a bit east of Hyrule Castle within the Crenel Hills.
Jump The Gaps
- Use Ultrahand to grab the platform that is on the ground. Place it on the right so it acts as a ramp. Then strike the yellow pillar to cause an Orb to drop down near the top of the room. It will roll down the steep slope and if positioned correctly, will roll right up the ramp that Link just created. It will cross the gap and land in the hole to the right, opening the nearby door.
- In the next room there is a square platform and a rectangular platform. Use Ultrahand to create an even longer platform. Just to the right as you enter this room, there is a treasure chest. Use these combined platforms as a bridge to get across. Open the chest here to get a Strong Zonaite Shield.
- Now carry the two platforms back and unstick them. This time attach them so that the smaller piece is perpendicular to the longer piece, and it's attached right at the corner. Turn it so that the long small piece is right at the edge of the platform. Then strike the yellow pillar, causing an orb to roll down. If positioned correctly, the orb will role up the large platform that you just created, launching itself across the gap and landing in the hole, opening the door.
- Run over to the altar and collect the Light of Blessing.
Video Walkthrough
Video Walkthrough of Ren-iz Shrine
Gallery
Arriving at the shrine
Use Ultrahand to place the platform so it works like a ramp
Be sure the front of it is all the up against the edge
The ball will jump the gap and into the hole
Use Ultrahand to attach the two platforms
Place the long platform across the gap and head across to find a chest containing a Strong Zonaite Shield
Attach the small platform at the edge of the larger platform so it is perpendicular
Place the platform to create a ramp
Again, be sure it is right up against the edge
